Skip to main content
Back to Strength Training
INTERMEDIATE

Using Partials & Pin Work for Strength

Practical overview of when and how to use partial reps and pin (rack) work to fix sticking points, increase lockout strength, and overload specific ROMs. Includes programming examples and alternatives for minimal equipment.

20 min
5 sections
0 uses
2 views

Equipment needed:

dumbbellsresistance bandsbox or bench (if available)
#strength#partials#pin-press#sticking-points#accessory-work
Added 18 Jan 2026

Workout Sections

1

Safety & technique cues

Notes
Always: full brace, neutral spine, controlled set-up into the pins, lift off the pins cleanly (no bouncing), and use a spotter for bench work when possible. Don’t use extreme overloads if you can’t maintain tight technique. If you have any joint pain or prior injuries, be conservative and consult a coach or clinician.
2

Overview - What they are & when to use them

Notes
Partials: deliberate work over a limited range of motion (top-half, bottom-half, mid-range) to overload a sticking region and improve force production. Use for: breaking plateaus, building confidence with heavier loads, and training a specific weak range. Pins (pin presses / rack work): starting a lift from a fixed position using pins in a power rack so the stretch reflex is removed; great for practicing specific joint angles and lockouts (bench lockouts, squat from above-parallel, rack pulls for deadlift). When to use: after technical work or as an accessory; not a replacement for full-range practice. Use 1–2x/week depending on cycle and fatigue.
3

Programming guidelines

Notes
Strength focus: 3–6 sets of 2–5 partial reps at heavy intensity (use a load 5–15% heavier than your full-ROM 1RM for that portion if safe). Rest 2–5 min. Hypertrophy / volume work: 3–4 sets of 6–12 partials with controlled tempo, 60–90s rest. Speed/power: lighter partials with fast intent, 4–6 sets of 1–3 reps, explosive intent, 90–120s rest. Frequency: 1–2 focused partial/pin sessions per week as accessory. Rotate ROM focus every 4–6 weeks.
4

How to choose pin height / partial ROM

Notes
Pick the pin height or partial range that corresponds to your sticking point. For bench: just off the chest (bottom), mid-chest (mid), or near lockout (top). For deadlift: just below the knee (pulling power), at mid-shin (initial drive), or high (lockout). For squats: set pins slightly below or above the depth where you struggle. Progression: start with slightly easier range, build load and reduce assistance over weeks. Track where you improve on the full lift.
5

Alternatives for basic equipment (dumbbells & bands)

Notes
If you don’t have a power rack with pins: - Bench lockout/top-half work: band-resisted lockouts, incline DB press with short ROM, or floor press for a shorter bottom ROM. - Bottom-half strength: floor presses, paused DB presses, or board alternatives (stacked mats/firm towels under the chest) to reduce ROM. - Deadlift lockout (rack pulls alternative): elevate DBs on blocks/plates to pull from a higher start. Single-leg RDLs or band-resisted Romanian deadlifts strengthen the posterior chain. - Squat partials: box squats to different heights, band-assisted bottom positions, or short-range goblet squats. Program these with the same set/rep templates above.

Start Training the Right Way Today

Join thousands of athletes using AI to perfect their form, prevent injuries, and accelerate their progress.

No credit card required • 7-day free trial • Cancel anytime